Hi all I've got some boxes of old bits that I've hoarded over the years, that I now think I really need to get rid of. 2x HP Jetdirect EX Plus Printserver (10 Mbit RJ45 + BNC). No PSU for these, they'll need a 13C DC centre-positive psu. 3x 56k external modems. One is a 3com US Robotics, the other two are unbranded as far as I can tell. I may have a 4th modem somewhere as well, I can't recall right now There are two PSUs that probably go with these, one is a 12V 1A PSU, the other is a multi-voltage 3V-12V, 0.5A one. 2x speedtouch pro DSL routers, with PSUs. Both were working fine when I last used them, which was around 3 years ago. 1x Compaq Evo T20 thin-client + PSU, part # 238365-001. This is probably running WinNT embedded, but it can be reflashed to run linux. 300Mhz processor, 64MB flash, 128MB RAM (I think). I put some notes up at http://www.wlug.org.nz/CompaqEvoT20Notes about reflashing them, and I think I still have the CDs of tools that I used, which I'll put in with this. There's quite a few resources on the internet for reflashing these too, eg http://www.mowson.org/karl/evo_t20/ and http://open-evot20.sourceforge.net/wiki/ Industrial patch cables. 7 x 2m, RJ45 (8P8C) to XP85, and 2x2m XP85 to XP85. XP85 is basically a secure screw fitting around an RJ45/8P8C jack. It looks like this: http://www.alternetivo.cz/industrial-patch-cord-utp-xp85-to-mc5-1-5m-yellow-boot_d19584.html?action=setlng&lngid=1& <http://www.alternetivo.cz/industrial-patch-cord-utp-xp85-to-mc5-1-5m-yellow-boot_d19584.html?action=setlng&lngid=1&> A fairly pristine looking 3Com Ergo Audrey. (http://en.wikipedia.org/wiki/3Com_Audrey). This is a very early internet appliance (~2000), running QNX. It's missing a PSU, and I don't know what condition it's actually in as a result. New PSUs can be purchased from http://www.audreymadness.com/, (they're a fairly non-standard pinout and voltage supply). I also have some old Fibrechannel gear. One Emulex LP8000, which had current driver support (lpfc.ko) in debian lenny at least, and two Compaq Tachyon adapters, which show up on the bus, but don't seem to have active drivers since around 2.6.8. There's still 2.4 kernel support for them however. There's also a pair of Compaq Fibrechannel Hubs. Everything has optical modules, and there's a few fibre patches as well. A Sun Netra T100, missing disks and ram. The disks are standard SCSI SCA disks, but the RAM is harder to source - you need "Mezzanine modules", like these: http://www.memoryxsun.com/netrat1.html. I had actually ordered some for it at one point, but the seller managed to lose my order. Pretty sure this system also has a quad-port 10/100 NIC in it, but if you want the NIC, you take the whole lot. Finally, my old desktop. Athlon 1800+XP, 1GB of ram (I think), single SATA disk (80GB?), DVD writer. PSU was changed not long before I stopped using it. I can't recall what the graphics card in it is, but it's not super flash. Was working fine when I stopped using it. All the above is free to whoever wants them, you must pickup from Hillcrest area, or from the CBD during business hours. No guarantee that any of it works. If it doesn't go here, I'll either put it for $1 reserve on trademe or dump it.