Hi there everyone I eran ethtool on my amd machine and this is the output: glenn(a)glenn-amd1:~$ sudo ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 1 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: d Current message level: 0x00000001 (1) Link detected: no glenn(a)glenn-amd1:~$ Since I have tried plugging the cable into another port on my switch, have tried changing ethernet cables, would it be correct to assume that the problem is faulty hardware? Glenn.
I eran ethtool on my amd machine and this is the output:
glenn(a)glenn-amd1:~$ sudo ethtool eth0
Settings for eth0: .... Link detected: no glenn(a)glenn-amd1:~$
Since I have tried plugging the cable into another port on my switch, have tried changing ethernet cables, would it be correct to assume that the problem is faulty hardware? Probably, although just to be sure run "sudo ifconfig eth0 up" and then run "sudo ethtool eth0" again. If you still do not get link after doing
that, try a different network card.
participants (2)
-
Daniel Lawson -
Glenn Stuart Morrissey