2 Feb
2010
2 Feb
'10
2:02 a.m.
[...]
Right, I did that. The only device shown was and got the error message:
SANE Message. IO Error while cxommunicating with the device.
Disconnected the scanner and reconnected after about five minutes. It was shown as Device 05 (002:005). However, going through the GIMP - Insane, I still get the same error message. :-(
Hmm... Don't know what's happening there. Maybe it's possible that you need to load the correct firmware? See the following wiki article: http://www.wlug.org.nz/Benq3300/4300ScannerSetup Cheers, Peter -- Peter Reutemann, Dept. of Computer Science, University of Waikato, NZ http://www.cs.waikato.ac.nz/~fracpete/ Ph. +64 (7) 858-5174