Hi, If you have a Raspberry Pi Model 3B, then you may be able use it with no micro SD-Card and have it boot Raspbian off a USB flash drive stick. I have found this possible with an Apacer AH356 64GB USB 3.1 Flash Drive<https://www.pbtech.co.nz/product/MEMAPC11464/Apacer-AH356-64GB-USB-31-Flash-Drive--Backwards-co> stick that I bought from PB-Tech a couple of weeks ago for $21.85. Admittedly you can buy a micro SD-card like the Apacer 64GB microSDXC UHS-I Class10<https://www.pbtech.co.nz/product/MEMAPC81064/Apacer-64GB-microSDXC-UHS-I-Class10-w-1-Adapter-RP> from PB-Tech for $28.75 and put Raspbian onto it. So using the USB flash drive stick only saves a few dollars. However, there may be other advantages over using a USB flash drive vs. a micro SD-Card for the Raspbian OS. For example, you can shutdown the Raspberry Pi and remove the USB stick, take it to another computer, and backup your data. I also installed the Raspbian distro onto WD Elements Portable 2TB 2.5" USB 3.0 External HDD<https://www.pbtech.co.nz/product/HDDWDX2621/WD-Elements-Portable-2TB-25-USB-30-External-HDD> which PB-Tech sell for $129. The R-Pi (with no SD-Card) would not boot this drive. Possibly because the USB drive is too slow to initialize after power on??? I also found that the R-Pi would not boot up Raspbian on an old 8GB Kingston USB flash drive. Maybe its too slow to initialize??? All the above tests were done using the current latest Raspbian release which is dated 2018_10_09. FYI: Below are details on how to install the Raspbian distro image onto a USB flash drive stick. cheers, Ian. Installing the Raspbian distro onto USB flash drive... Download the latest 1.4GB Raspbian distribution file: 2018-10-09-raspbian-stretch.zip Unzip the file to create a 4.1GB image file: 2018-10-09-raspbian-stretch.img Copy the 4.1GB image to a USB flash drive stick... $ sudo dd bs=4M if=2018-10-09-raspbian-stretch.img of=/dev/sdX status=progress conv=fsync Note: For the device /dev/sdX replace the X with the drive letter of your USB flash drive stick. e.g. /dev/sdc Insert the USB flash drive stick into the R-Pi model 3B. Remove any SD-Card that may be installed in the Raspberry Pi. Power on the R-Pi. After about 10 seconds the colourful POST display will appear, and the USB stick will commence its first boot. It will detect that it is a 4.1GB partition, expand to being a partition that fills the whole of the USB flash drive stick and reboot. The second reboot will be slow and takes about one minute. I assume it is expanding the squashed file system??? Subsequent reboots are faster.